Sony BVP-9500WS, Руководство по обслуживанию

Страница: 46 / 390

1-36 (E)
BVP-9500WS/9500WSP MM
1-7. Replacement of Filter Disk Unit
c
When opening the side panel during or immediately after use of the unit, be careful as the board panel is
very hot and touching it may result in burns. When opening the side panel to perform inspections and
adjustments, turn off the power and wait 10 minutes for the unit to cool down first.
1. Remove the right side panel. (Refer to Section 1-4 in the installation and maintenance manual.)
2. Loosen the two screw, and pull out the filter disk unit.
Disconnect the harness connector from the connector of the filter disk unit.
3. Install a new filter disk unit in the reverse order of removal.
[Note|at|installation]
.
At installation, do not touch the surfaces of filters.
. Confirm that the MOTOR switch of the filter disk unit is on.
4. After replacement, white balance adjustment is required. Refer to Section 3-6 for details on adjust-
ment.
1-7. Replacement of Filter Disk Unit
MOTOR switch
Filter disk unit
Screws
Connector