Sony BVP-9500WS, Руководство по обслуживанию, Страница: 113 / 390

3-41 (E)
BVP-9500WS/9500WSP MM
RV6
RV7
RV8 RV9
RV10
VR1
VR8
VR7
VR6
VR2
VR3 VR5
VR4
VR9
VR10
Servo driver board (A)
* Servo driver boards (A) and (B) are compatible.
Servo driver board (B)
RV1
RV2
RV3
RV4
RV5
3-5. Filter Positioning Adjustment
Notes
. This adjustment is required only when replacing the servo driver board in the filter disk unit.
. The filter disk unit has adjustment controls inside . To adjust them, the filter disk unit should be
removed from the CCD unit. After adjusting each control, reinstall to check filter positioning by
viewing from the lens mount.
Repeat the actions shown above until all filters are correctly positioned.
Preparation
MOTOR switch/servo driver board
→
ON
Adjustment Procedures
1. ND 1 button (MSU-700A)
→
ON
2. Adjust
1
RV1 (VR1) on the servo driver board so that the ND 1 (clear) filter stops at a click position
(on the optical axis of the lens) when viewed from the lens mount.
3. Adjust 1 RV6 (VR6) so that the CC 1 (cross) filter is aligned with the ND 1 filter when viewed from
the lens mount. After that, align positioning for the CC 2 to CC5 filters in the same manner.
4. CC 1 button(MSU-700A)
→
ON
5. Adjust
1
RV2 (VR2) so that the ND 2 filter is aligned with the CC 1 filter when viewed from the lens
mount. After that, align positioning for the ND3 to ND5 filters in the same manner.
6. Install the filter disk unit in the CCD unit. Check that all filters are correctly positioned while press-
ing the ND and CC buttons on the MSU-700A one by one.
Filter Adj. points (A) (B)
ND 1 (clear) 1 RV1 1 VR1
ND 2 (1/4 ND) 1 RV2 1 VR2
ND 3 (1/8 ND) 1 RV3 1 VR3
ND 4 (1/16 ND) 1 RV4 1 VR4
ND 5 (1/64 ND) 1 RV5 1 VR5
CC 1 (cross)
1
RV6
1
VR6
CC 2 (clear) 1 RV7 1 VR7
CC 3 (4300 K) 1 RV8 1 VR8
CC 4 (5600 K) 1 RV9 1 VR9
CC 5 (8000 K) 1 RV10 1 VR10
3-5. Filter Positioning Adjustmentt