Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/90 A
Sony Ericsson Mobile Communications AB
8(62)
Step-by-Step Instructions
26. There are 5 latches that hold the circuit board in
the back cover. To release the circuit board,
gently pry between the circuit board and the
back cover in the 4 locations indicated in the
order specified.
NOTE! Only pry as much as is needed to
release the latches!
NOTE! When prying in location 2 make not to
pry over the portion of the antenna that
is visible.
NOTE! Be careful not to damage the RF port
when prying to release the latches at
location 2.
27. Once the latches holding the circuit board are
released, slightly lift up the side of the circuit
board the display is adjacent to and using a pry
tool, carefully disconnect the flex connection of
the display from the circuit board. Then set the
display aside.
28. Once the display is removed, increase the size of
the opening between the circuit board and the
back cover and locate the jog dial flex film
connection.
29. Using a pry tool, carefully disconnect the flex
connection of the jog dial from the circuit board.
