Sontex Superstatic 470 SPF, Руководство пользователя

Страница: 5 / 20

2. Instructions for installation
2.1 Communication interface
The Superstatic 470/479 contains a heat pump-Module, i.e. an additional double module with an
M-Bus output, four configurable non-galvanically separated digital inputs and a temperature
sensor input (not operational at present).
The main connection board of the computer unit has two additional inputs.
Heat pump module
2.2 Safety notes
Before using the Superstatic 470/479, avoid electrostatic discharges during fitting or use. Before
touching the computing unit or the heat pump module, you are advised to touch an earthing source
(e.g. a water pipe or a hot water pipe) to effect an electrical discharge from your own person.
2.3 Recognition of the heat pump module
By means of the Prog470/Prog479 software the configuration of the Superstatic 470/479 and the
parameterisation of the inputs used for calculation of the performance factors can be detected and
displayed.
2.3.1 Recognition of the heat pump module with the SW Prog470/479
The Prog470/479 software allows the recognition of the heat pump module and provides the
following information:

Firmware version of the heat pump module

Configuration of the M-Bus interface

Configuration of the four digital inputs
If the software has detected the heat pump module, the following parameters can be configured:
M-Bus interface:

Transmission speed

Primary address

Identification number

Reaction time

Parity
Digital inputs:

Counting type: deactivated/pulse counting/Operating time counting/Time factor for each
digital input

Determination of the units

Pulse factor value
0470P004 Manual Superstatic 470 SPF 02-03-2015 5