SOMFY Sonesse Utra 50 DC, Инструкция по эксплуатации

Страница: 5 / 16

5
Copyright © 2016 Somfy SAS. All rights reserved.
EN
Images not contractually binding
2.1.2. Tube preparation
1) Cut the roller tube to the required length, depending on the motorised product.
2) Deburr the roller tube and remove the swarf.
2.1.3. Motor/tube assembly
1) Slide the motor into the roller tube.
2) The motor wheel must be locked in place to prevent movement inside the roller
tube:
• This can be done either by fixing the roller tube to the motor wheel using 4 x Ø 5
mm self-tapping screws, or by using 4 x Ø 4.8 mm steel pop rivets placed 5 mm
to 15 mm from the outer edge of the motor wheel, regardless of the roller tube.
The screws or pop rivets must only be attached to the motor wheel and not to
the motor.
3) Slide the end cap into the roller tube and locked it if necessary.
2.1.4. Installing the motor/tube assembly
The motorised product must not be compressed between the brackets
1) Install and fix the motor/tube assembly onto the end bracket
f and onto the motor
bracket
g:
Ensure that the motor/tube assembly is secured onto the end bracket. This
operation prevents the motor/tube assembly from coming out of the end
bracket mounting when the roller blind reaches the lower end limit position.
2) For star head motors, ensure the stop ring h in place.
2.2. WIRING
Cables which pass through a metal wall must be protected and isolated using a grommet or sleeve.
Attach cables to prevent any contact with moving parts.
The cable on the Sonesse ULTRA 50 can be removed. If it is damaged, replace it with an identical cable.
Leave the motor power supply cable accessible: it must be possible to replace it easily.
-
Switch off the power supply.
-
Connect the cable to the motor head.
1)
2)
h
g
f


15 mm
5 mm
20 mm
L1
1)
2)
3)
1) 2)

V+
V-
V+
V-
