SOMFY Sonesse Utra 50 DC, Инструкция по эксплуатации

Страница: 4 / 16

4
Copyright © 2016 Somfy SAS. All rights reserved.
EN
Images not contractually binding
1.2 LIABILITY
Before installing and using the motor, please read operating and installation guide carefully. In addition to following the instructions
given in this guide, the instructions detailed in the attached
Safety instructions document must also be observed.
The motor must be installed by a motor and home automation professional, according to instructions from Somfy and the
regulations applicable in the country in which it is commissioned.
It is prohibited to use the motor outside the fields of application described above. Such use, and any failure to comply with the instructions
given in this guide and in the attached
Safety instructions document, absolves Somfy from any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the motor and must provide them with the
instructions for use and maintenance, and the attached
Safety instructions document, after installing the motor. Any After-Sales Service
operation on the motor must be performed by a motor and home automation professional.
If in doubt when installing the motor, or to obtain additional information, contact a Somfy adviser or go to the website www.somfy.com.
1. 2. INSTALLATION
Instructions which must be followed by the motor and home automation professional installing the motor.
Never drop, knock, drill or submerge the motor.
Install a separate control point for each motor.
To optimize ultra quiet operation, the mechanical plays between motor, accessories, tube and end of tube must be decreased to the
maximum.
2.1. INSTALLATION
2.1.1. Preparing the motor
Check that the inner diameter of the tube greater than 47mm.
1) Fit the accessories required to integrate the motor in the roller tube:
• Fit the crown a, the motor wheel b and the stop wheel c on the motor.
The stop wheel must be screwed with a torque ranging between 1.5 and 1.8 Nm.
2) Measure the length (L1) between the inner edge of the motor head and the edge of
the motor wheel.
3) Screw the bracket interface on the motor head.



Safety warning!
Information

Caution!

1)
L1
L1 = …
2)
Ø > 47 mm
b a
3)