Copyright © 2010 Somfy SAS. All rights reserved.
Pergola sc io
42
EN
6. OPERATION
5.5. Programming the first Somfy io local control point
5.5.1. Using a pre-programmed Somfy io local control point
Briefly press the PROG button on this control point (G):
-
the blind will make a brief movement; the control point
has been programmed.
or
5.5.2. After a power cut
When the power is switched on, the blind makes a brief movement.
Press the Up and Down buttons simultaneously on the
1)
new control point (H) until the blind moves briefly.
Briefly press the PROG button on this control point
2) (H):
the blind will move briefly; the control point has been
programmed.
5.6. Checking the settings
Check the settings of the upper and lower end limits using the Somfy io local control point.
-
PROG. G
2
PROG. H
H
1
6.1. Standard operation
6.1.1. Up and Down buttons
Briefly press the Up or Down button to raise or lower the blind
fully.
6.1.2. STOP function
The blind is moving.
Briefly press the "my" button: the blind will stop.
-
6.1.3. Favourite position (my)
Definition
Besides the upper and lower positions, an intermediate position known as the "favourite (my) position"
may be programmed in the motor.
A favourite position is stored automatically. To modify the favourite (my) position, see the section
entitled "
Additional settings
".
To use the favourite (my) position:
Briefly press the "my" button: the blind will start to move,
-
and stop in the favourite position (my).
6.1.4. Fabric tension (my)
Position the blind at the lower end limit
1)
2)
Ensure that the latches are locked.
Briefly press the "my" button: the blind will start to move
3)
(lower then raise) and stop automatically to tension the
blind fabric.
6.2. Operating with a Somfy io sensor
Refer to the corresponding guide.
6.3. Feedback
After each order, the Pergola sc io sends a message. This
information is processed by the io two-way control points.
my
my
1
2
3
Markizy.by
