Copyright © 2010 Somfy SAS. All rights reserved.
Pergola sc io
41
EN
5.4. Setting the end limits
5.4.1. Semiautomatic end limit setting for vertical blinds
For vertical blinds with a cassette, the upper end limit is set automatically, while the lower
end limit must be set manually.
It is always possible to define a new lower end limit before programming it.
Setting the lower end limit
For vertical blinds with latches, position the blind level with or below the latches.
Put the blind in the lower end limit position.
1)
Press and hold the Down button for > 2 seconds to
lower the blind in one continuous movement.
Stop the blind at the desired point.
2)
If necessary, adjust the position of the blind using the Up
3)
or Down buttons.
Press the "my" and Up buttons simultaneously: the blind
4)
will be raised in one continuous movement, even after
the "my" and Up buttons have been released.
At mid-height, briefly press the "my" button to stop the
5)
blind.
Press the "my" button again until the blind moves briefly:
6)
the end limits have been programmed. Go to the section
"
Programming the first Somfy io local control point
".
5.4.2. Manually setting the end limits on vertical blinds
For vertical blinds without a cassette, the upper and lower end limits must be set.
It is always possible to define new upper or lower end limits before programming them.
Setting the upper end limit
Position the blind at the upper end limit.
1)
Press and hold the Up button for > 2 seconds to raise
the blind in one continuous movement.
Stop the blind at the desired point.
2)
If necessary, adjust the position of the blind using the Up
3)
or Down buttons.
Press the "my" and Down buttons simultaneously: the
4)
blind will be lowered in one continuous movement, even
after the "my" and Down buttons have been released.
At mid-height, briefly press the "my" button to stop the
5)
blind and go to the next step.
Setting the lower end limit
For vertical blinds with latches, position the blind level with or below the latches.
1) Put the blind in the lower end limit position.
Press and hold the Down button for > 2 seconds to
lower the blind in one continuous movement.
Stop the blind at the desired point.
2)
If necessary, adjust the position of the blind using the Up
3)
or Down buttons.
Press the "my" and Up buttons simultaneously: the blind
4)
will be raised in one continuous movement, even after
the "my" and Up buttons have been released.
At mid-height, briefly press the "my" button to stop the
5)
blind.
Press the "my" button again until the blind moves briefly:
6)
the end limits have been programmed. Go to the section
"
Programming the first Somfy io local control point
".
1
3
5
2
4
6
2 s
1
3
5
2
4
Setting the lower
end limit
1
3
5
2
4
6
2 s
Markizy.by
