Solwave 180MW1000D, Руководство пользователя

Страница: 39 / 46

10
USER MANUAL
GENERAL CLEANING CONTINUED
Instructions:
1. Follow General Cleaning instructions (above).
2. Remove any inset pans and drawer pans. Wash thoroughly in the sink or dishwasher.
3. Remove drawers: Remove pans and pan inserts. Extend drawer and lift up on the front to clear the drawer stop.
Lower drawer and pull straight out.
4. If Lime or Mineral build-up occurs, follow below guide on “Removing Lime and Mineral Deposits”.
Removing Lime and Mineral Deposits:
1. Turn off the unit, and allow the unit to cooldown.
NOTE: For freestanding units, always unplug the unit when servicing or cleaning. For built-in units, turn the
control knob to the “OFF” position and allow up to 1 hour to cooldown before servicing or cleaning.
2. After the unit has cooled, remove and empty the water pan.
3. Fill the water pan with a mixture of 75% water and 25% white vinegar to a level where it covers the lime and
mineral deposits.
4. Install the water pan with deliming solution into the unit.
5. Plug in and turn on the unit. Allow the unit to run for 30 minutes.
6. Turn off the unit and unplug the power cord (freestanding models).
7. Allow the water pan to stand with the deliming solution for at least two hours (the time required will vary
depending on the amount of deposits in the water pan).
8. Remove the water pan and empty the deliming solution.
9. Continue to fill and rinse the water pan with clean water until the pan is clean.
10. Install the clean water pan into the unit. Plug in the unit and fill the water pan as usual for daily operation (1/4"
of water is recommended).
NOTE: If lime and mineral deposits are still present in the water pan, repeat this procedure and increase the
amount of time the de-liming mixture stands in the water pan.