CSW-H85K2 User Manual Ver. 1.2
- 59 -
⚫
ARP Table / ND Cache Table
This part shows ARP table on CSW-H85K2. When TCP connection is established or
UDP data communication is performed, the information of IP and MAC address is
automatically registered in the table. This information lasts for 1 minute so when 50
seconds has passed, CSW-H85K2 starts broadcasting the ARP packet in every second.
If there is no response until the time is 0, the information is removed. Otherwise, the
time is updated 60 seconds again.
In IPv6 case, it shows ND cache table. User can check by the ND cache messages. The
messages are as follows.
State
Description
INCOMPLETE
This means the device is standing by after it sends the
request message, Neighbor Solicitation, to MAC and link
local address of an opponent in the initial communication.
REACHABLE
This means the device has information about the opponent
after it sends Neighbor Solicitation, and receives Neighbor
Advertisement.
STALE
The device will change into STALE state after some time later
reaching REACHABLE.
DELAY
The device will change into DELAY state if there is no
response to Neighbor Solicitation. In this case, CSW-H85K2
will not be able to communicate with the device.
PROBE
CSW-H85K2 will resend the request message to the device in
DELAY state. CSW-H85K2 will keep sending Neighbor
Solicitation until it replies.
Table 6-4 5 states of ND cache table
⚫
Wi-Fi Status
Status of Wireless LAN Channel is displayed.
Item
Description
Channel
Current channel (Frequency band)
Link Speed
Maximum data rate of the link (Unit: Mbps)
RSSI
Received Signal Strength Indication (Unit: dBm)
RSNA
Current authentication algorithm (WEP, TKIP, CCPM)
Table 6-5 Wi-Fi status
