1. Hang the door panels (POS. 22).
2. Align them by adjusting the hinges using a hex wrench.
3. If the door
panels are too far away from each other
at the center or are angled,
take the following steps:
a. Remove the off the hinges.
b. Use a hex wrench to twist the hinges on the panel in question outwards.
Only adjust in no more than 1 full rotation increment.
c. Adjust each of the three hinges by an equal amount if the door is straight; or
by an incrementally lesser amount for each respective hinge, i.e., as 1 full
rotation at the top, ¾ rotation in the middle, and ½ rotation at the bottom.
d. Return the door panels on the hinges, and check the alignment.
e. Repeat the steps above until the door is even and have a ¼" gap between the
two panels.
4. If the door panel is rubbing at the bottom, adjust the
hinges that are on the door
frame
:
a. Remove the door off the hinges.
b. Use a hex wrench to bring up the pin inside the hinge on the door frame. It's
the bolt that's set at an angle.
c. Bring up each hinge pin by an even amount.
d. Return the door panels on the hinges, and check the alignment.
e. Repeat the steps above until the door opens and closes smoothly.
NOTE
. The door will need periodical adjustments as the whole structure settles. It may
take 2-4 weeks until it has acclimated, though seasonal variations may require additional
adjustments if weather conditions in your area get extreme.
STEP 14 - INSTALL THE DOOR PANELS
37
BRIGHTOLN 10 x 10 ft, 1
3
/
8
"
Содержание BRIGHTON
Страница 4: ...BRIGHTON 10 ft x 10 ft 1 3 8 ...
Страница 13: ...13 1 FLOOR JOIST DIAGRAM Position Dimension in Quantity 1 109 3 8 x 2 3 8 x 1 1 2 7 BRIGHTOLN 10 x 10 ft 1 3 8 ...
Страница 40: ...40 STEP 16 FASTEN THE DOOR PANELS WINDOW 3x25mm BRIGHTOLN 10 x 10 ft 1 3 8 4x40mm x4 ...
Страница 42: ...INSIDE OUTSIDE LOCK CYLINDER STEP 17 INSTALL DOOR WINDOW HARDWARE 42 BRIGHTOLN 10 x 10 ft 1 3 8 ...