Controller
• Independent Control of 2 single color LED Zones
• Dimming from 0% to 100% brightness
• 12V to 24V DC Operation
Technical Information
Page 9
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
Receiver
• Operating Voltage 12V DC to 36V DC
• 4 x 5A Output Channels
• Overheat Protection
• Short Circuit Protection
• PWM Dimming
• Control up to Four Single Color LED fixtures simultaneously
• 240W (at 12V DC)
• 480W (at 24V DC)
PRODUCT MANUAL
Onyx 2 Zone In-Wall Wireless
LED Dimmer and Receiver
On
yx 2 Z
one I
n-
W
all
W
ireless LED Dimmer
If you are having problems with the lights responding to the Onyx 2 Zone Dimmer in either zone, first check that the
dimmer is within range of the receiver (50 feet maximum).
Check that the lights in the zone are on, and the wiring to and from the receiver matches the diagram on page 4. Check
that the wiring to the Onyx 2 Zone matches the wiring diagram on page 5.
If there is power going to the receiver and the lights do not shine when turned off and on, the Onyx 2 Zone could be
dimming the lights in that zone. Press and hold the on button until the lights brighten, then let go of the button when
the lights have reached the desired level of brightness.
You can re-pair the Onyx 2 Zone and the receiver by following these steps:
1
2
3
4
This section will show you how to troubleshoot the Onyx 2 Zone Dimmer and Receiver.
Troubleshooting
On the receiver, hold the Learning Key button down for 10 seconds. This will reset the system to its default
setting.
First, select the zone you want to re-pair. Each zone has to be re-paired separately.
Push the Learning Key button once, then touch the on button then the off button quickly several times until
the lights blink. The dimmer and receiver for the selected zone are now paired.
B
A
C
