Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
Installation
Solid Apollo’s Onyx 2 Zone Dimmer and Receiver can control up to two single color LED zones independently, for zones running from
12V to 24V DC. After the installation is complete, you can change the brightness on each LED zone independently from 0% to 100%
brightness.
Setting up the dimming system:
Tools Required:
Philips Screwdriver
Flat Head Screwdriver
Wire Stripper
First, the power supply connects to the left side of the receiver (uses 12 - 24V DC). Make sure the power supply is not
plugged in. Take the negative wire, and using the Wire Stripper, strip off approximately 1/4” of cover from the end of the
wire. Twist the exposed metal wire to help make a secure connection.
This section will show you how to complete the wiring for one zone with a single receiver, which will connect the power supply for up to
four LED fixtures. Only one LED fixture is required per receiver. To wire another zone, repeat the following steps with another receiver.
PO)
NEGATIVE(-)
(+)
(-)
(+)
(-)
(+)
(-)
(+)
(-)
Power
Source
LED fixture 1
LED fixture 2
LED fixture 3
LED fixture 4
1
Remove the white plastic end caps on both ends of the receiver using the Philips screwdriver. This will expose the green
wiring slot blocks.
2
...continued on next page
Page 2
PRODUCT MANUAL
Onyx 2 Zone In-Wall Wireless
LED Dimmer and Receiver
On
yx 2 Z
one I
n-
W
all
W
ireless LED Dimmer
