™
Repeat the last step, but instead using the positive wire and the second from the left wiring block (labeled Vin).
The rear mounting base is snapped onto the face of the Onyx 2 Zone. Using a flat head screwdriver, carefully insert the tip
into the notch at the end of the Onyx 2 Zone. Slowly pull the handle of the screwdriver upwards and then downwards to
help release the rear mounting base.
Take the wired rear mounting base and place it against the wall location with the switch gang box. Make sure to place
the back of the base into the wall with the opening notch (from step four) facing down.
3
4
5
Page 6
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
PRODUCT MANUAL
Onyx 2 Zone In-Wall Wireless
LED Dimmer and Receiver
On
yx 2 Z
one I
n-
W
all
W
ireless LED Dimmer
Take one of the provided screws and insert it into the top hole of the rear mounting base. Take the Philips screwdriver
and begin tightening the screw in a clockwise direction. At this time, make sure any extra wiring is tucked carefully
behind the rear mounting base. Take the second provided screw and insert it into the bottom hole of the rear mounting
base. Take the Philips screwdriver and being tightening this screw. Tighten down the top screw until it is snug and flush
with the wall. Repeat this process with the lower screw.
6
