On the left green wiring slot block for the power supply, use the Philips Screwdriver to rotate the negative wiring screw
counter clockwise to open the wiring slot located below the screw. The screw will not come out.
3
Take the negative wire and insert the exposed metal end into the negative wiring slot located below the screw. Place
the wire inside until the wire stops against the wall inside the negative wiring slot. Take the Philips Screwdriver and
turn the negative wiring screw clockwise until the screw is snug. The negative wire has now been secured to the receiver
and should not come out. If it does come out, repeat from step two, and place the exposed metal wire further into the
negative wiring slot.
4
Repeat steps two through four for the positive wire of the power supply. The positive wire will go into the positive wiring
slot.
5
Page 3
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
...continued on next page
On the right side of the receiver, connect the first LED fixture. First, take the negative wire, and repeat steps two through
four above, but connect the wiring in the right side green wiring block using the negative wiring slot. Repeat again for
the positive wire but using the positive wiring slot.
6
Power
Source
12-
24V DC
NEGATIVE(-)
PO)
Power
Source
12-
24V DC
PRODUCT MANUAL
Onyx 2 Zone In-Wall Wireless
LED Dimmer and Receiver
On
yx 2 Z
one I
n-
W
all
W
ireless LED Dimmer
