Page 7
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
PRODUCT MANUAL
Onyx 2 Zone In-Wall Wireless
LED Dimmer and Receiver
Make sure the LED zone(s) and power supply are turned on and correctly connected. On the receiver, push the Learning
Key button once. On the Onyx 2 Zone, push the on and off button repeatedly until the lights on the LED fixture(s) flash.
The flash indicates the receiver and the dimmer are paired. This should happen within the first five seconds. The Onyx
2 Zone is now ready to work.
1
On
yx 2 Z
one I
n-
W
all
W
ireless LED Dimmer
This section will show you how to pair your new Onyx 2 Zone Dimmer with the receiver for one zone.
Pairing the Onyx 2 Zone Dimmer and Receiver
Learning Key Button Location
- Dimmer On (Touch Once)
- Increase Brightness (Hold
Down Button)
- Dimmer Off (Touch Once)
- Decrease Brightness (Hold
Down Button)
Mount the face plate of the Onyx 2 Zone by first aligning the notch at the bottom so it lines up with the rear mounting
plate. If they are not aligned the face plate will not snap into place. Place the face over the rear mounting base and
carefully push on the top and bottom until the face snaps into place and is flush at the top and bottom of the wall. The
Onyx 2 Zone is ready to pair with up to two LED zones.
7
