™
This section will show you how to connect the power source wiring and mounting the Onyx 2 Zone.
Wiring Power and Mounting the Onyx 2 Zone Dimmer
On the back of the rear mounting base are the green wire mounting boxes. The power supply will be connected to the far
left wire mounting blocks. Using a Philips Screwdriver, unscrew the far left wire mounting screw in a counterclockwise
direction. This block is for the Negative (Ground) wire.
Take the negative wire, check the wire coating has been stripped from the wire (see page 2 step 2 if wire requires
stripping), and insert the exposed end below the mounting block screw (labeled GRD). Take the Philips Screwdriver and
re-tighten the screw clockwise until the screw is snug and the wire does not easily pull out.
1
2
Wiring Diagram for Dimmer
Page 5
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
...continued on next page
PRODUCT MANUAL
Onyx 2 Zone In-Wall Wireless
LED Dimmer and Receiver
PO)
NEGATIVE(-)
Power
Source
On
yx 2 Z
one I
n-
W
all
W
ireless LED Dimmer
