Solas FIN-36N, Руководство по установке и эксплуатации

Страница: 12 / 34

12
VENTING
Feed chimney liners down the chimney and through the
damper.
Position the Solas Fireplace Insert in front of the fire-
place opening to prepare for Installation.
Locate the Vent Connector
Plate locking bar on the top
of the unit
Lift up on the locking bar to
release.
Push bar towards the rear,
sliding the Vent Connector
Plate halfway down in its
locating track. At this point
it will be possible to re-
move the plate from the
fireplace insert body by lift-
ing the plate upwards
Take care not to damage
the sealing gasket affixed
With the Vent Connector Plate separated from the unit,
attach the flex liners you have dropped into the fire-
place cavity to the plate using hose clamps, making
sure that the Intake and Exhaust are connected to the
correct collars. Remember the exhaust liner is the one
that was marked with paint earlier.
Vent Restrictors
Installations with extended vent runs may experience
over-drafting and require the addition of a Vent Re-
strictor (E or F). The best indication of over-drafting is
a hyper-active flame pattern (flames that move too
quickly). Over-drafting may affect the pilot, causing it
to lift off the flame sensing rod shutting off the unit.
Too much restriction will lead to ghosting or lifting
flames - in this case less restriction is required.
The Solas Fireplace is supplied with two restrictor
plates and provide restriction as follows:
No Restrictor Plate
— No Restriction
Plate “E” 1.75” diameter— Maximum Restriction
Plate “F” 2.00” diameter. — Minimum Restriction
Determine the flue restrictor needed for this application
and install into the exhaust port on the insert body.
•Natural gas uses no restrictor from 10’ to 22’ and the
1.75”ID (E) restrictor from 22’ to 36’.
•Propane uses no restrictor for 10’ to 22’ and the 2.0”
ID (F) for the 22’ to 36’ chimneys.
Removable Venting Connector Plate
The Solas Fireplace Insert is
equipped with a removable
Venting Connector Plate. Re-
move this plate from the unit
as follows:
Air Intake
Exhaust
Exhaust Air Intake