SOLARFOCUS maximus 150, Руководство по эксплуатации

Страница: 20 / 40

6 Installation
6.4 Install the feeder unit
► Mount the feeder unit 1 including installed rotary
valve, to the burner with 4 pcs. hexagonal screw;
enclose seal
2 .
►
Set adjustable foot 3 .
►
Connect the feeder motor 4 to the cable FU1 pre-
routed in ducts 3 and 2 > 31 : U,V,W .
i
Check - swap two phases if the direction of
rotation is wrong.
Fig. 2-28: Install the feeder unit
Install the feeder sensor
► Fix the feeder sensor 1 in the retaining tube
► Connect to A1:X33 , cable is pre-routed in ducts 3
and 2 > 31 .
Fig. 2-29: Install the feeder sensor
Connect the feeder motor
► Connect the pre-routed cable as shown in the ter-
minal area of the motor.
Fig. 2-30: Connect the cable in the motor terminal area
6.5 Install safety valve
►
Install the safety valve in the boiler supply line, at
the highest point of the line, as close as possible
to the boiler. Observe installation position.
!
CAUTION - Do not install any barriers in the
pipework that could render the boiler safety
group ineffective.
6.6 Install return booster
Information on return booster > 24
20 Operation manual maximus