Solahart ATMOS AIR 270, Руководство по эксплуатации и установке

Страница: 32 / 40

6.Maintenance and repair
29
g.Where the water heater is installed in a position that does not allow safe or ready access,
the cost of that access, including the cost of additional materials handling and/or safety
equipment, shall be the owner’s responsibility. In other words, the cost of dismantling or
removing cupboards, doors or walls and the cost of any special equipment to bring the water heater
to floor or ground level or to a service
able position is not covered by this warranty.
h.This warranty only applies to the original and genuine Solahart water heater in its original
installed location and any genuine Solahart replacement parts.
I.The Solahart warranty does not cover faults that are a result of:
i
.Accidental damage to the water heater or any component (for example: (i) Acts of God such
as floods, storms, fires, lightning strikes and the like; and (ii) third party acts or comissions).
ii.Misuse or abnormal use of the water heater.
iii.Installation not in accordance with the Owner’s Guide and Installation Instructions or
with relevant statutory and local requirements in the State or Territory in which the water
heater is installed.
iv.Connection at any time to a water supply that does not comply with the water supply
guidelines as outlined in the Owner’s Guide and Installation Instructions.
v.Repairs, attempts to repair or modifications to the water heater by a person other than
the Solahart Dealer or a Solahart Accredited Service Agent.
vi.Faulty plumbing or faulty power supply.
7.Appendix
7.1 CAUTION
1. To reduce the risk of excessive pressures and temperatures in this water heater, install
temperature and pressure protective equipment required by local codes and no less than a
combination temperature and pressure relief valve certified by a nationally recognized testing
laboratory that maintains periodic inspection of production of listed equipment or materials, as
meeting the requirements for Relief Valves and Automatic Gas Shutoff Devices for Hot Water
Supply Systems, ANSIZ21.22. This valve must be marked with a maximum set pressure not to
exceed the marked maximum working pressure of the water heater. Install the valve into an
opening provided and marked for this purpose in the water heater, and orient it or provide
tubing so that any discharge from the valve exits only within 6 inches above, or at any distance
below, the structural floor, and does not contact any live electrical part. The discharge
opening must not be blocked or reduced in size under any circumstances.
3. Children should be supervised toensure that theydo not playwith the appliance.
4. Theappliance is fittedwith means fordisconnection from thesupply mains havinga
contact separation inall poles thatprovide full disconnection under overvoltage categorylll
conditions, and thesemeans must beincorporated in thefixed wiring inaccordance with the
wiring rules.
2. Hydrogen gasis produced ina hot watersystem served bythis heater thathas not been
used for along period oftime (2 weeksor more). Hydrogengas is extremelyflammable. To
reduce the riskof injury underthese conditions, itis recommended thatthe hot waterfaucet
be opened forseveral minutes atthe kitchen sinkbefore using anyelectrical appliance
30