硕飞科技
SHENZHEN SOFI TECHNOLOGY www.sofi-tech.com
User Manual
7
SP16 Series programmer
5. Load programming file
Click toolbar button
，
or menu [File] - [Load File] to load the data file of program.
6. Set operation options
Click the toolbar button
，
or menu [Operation] - [Operational Options] to device
programming settings. In most cases, you can use the default settings. For details on the operation
options, please refer to the helper topic of the programmer software.
7. Place device to ZIF Socket
The DIP packaged device can be directly inserted, and the non-straight-inserted device needs to be
matched with IC socket. In this example, an SOP8 wide-body programing seat is used. First, lift ZIF
Socket’s handle, insert the bottom side of IC socket into the bottom of ZIF Socket, press the handle, and
then put the device into IC socket. Pay attention to the direction of the first leg of device.
Physical map
Device pin position diagram
For other device
s’ placement (including IC socket information), please open the device information in the
FlyPRO software for viewing. Most of 8-pin devices are inserted into ZIF Socket according to the
corresponding relationship on the right. A very small number of devices are placed in a special way.
Please pay attention to the prompts that the software pops up.
Note:
ZIF Socket is only used to place the device to be programmed (including IC socket). It is forbidden
to programming devices which have already been welded on circuit board, through wires from ZIF
socket. The peripheral circuit on the board will cause the operation to fail. Serious conditions can cause
permanent damage to the programmer hardware. The manufacturer is not responsible for any
consequences that may result from this incorrect operation. The EMI method is recommended for the
device that has been soldered. Please refer to "Chapter 5. ISP Programming".
8. Perform programming
There are three modes for programming, including manual mode, automatic mode, and automatic mass
production mode. Choose one of the modes to operate according to different situations.
Manual mode
Select the "Manual Operation" page in the command bar on the left side of the main software window.
Follow the typical operation steps according to the device type.
Pin1
Pin1
