硕飞科技
SHENZHEN SOFI TECHNOLOGY www.sofi-tech.com
User Manual
14
SP16 Series programmer
Chapter 5. ISP Programing
The ISP is called In System Program, which is on-line programming. The ISP programming mode only
needs to connect several signal lines to the relevant pins of the onboard device to be read and written,
which can eliminate the trouble of removing and soldering devices.
Use ISP programming mode
The SP16 series programmer only supports ISP mode programming of some devices. When the device
model with the "[ISP]" suffix is selected in the software, it means that ISP mode is used for programming.
(Selecting the device mode without ISP suffix, you can only program it through ZIF Socket. Do not select
wrong mode for both programming methods.)
Note: ISP program should use a dedicated ISP interface to connect, do not connect through wires from ZIF
socket.
ISP interface
The SP16 Series Programmer provides an additional ISP interface as shown below:
ISP/ATE interface ISP interface definiens
ISP Cable
The ISP cable is a 10-color color cable with a 5x2 standard plug on one end and access to the
programmer's ISP/ATE interface. The other end is 10 DuPont connectors that are connected to the
corresponding pins on the target board. The following figure shows the BIOS upgrade for the ASUS
motherboard with SPI interface reserved.
ISP/ATE
接口
1
9
7
5
3
2
10
8
6
4
接口引脚图
