6
EN
MASTERYS BC+ 60-80 kVA - Ref.: IOMMASBCXX0F-EN 00
2. SAFETY STANDARDS
This user manual specifies installation and maintenance procedures, technical data and safety instructions for
SOCOMEC. For further information visit the Socomec website: www.socomec.com.
NOTE!
Any work carried out on the equipment must be performed by skilled, qualified technicians.
DANGER!
Failure to observe safety standards could result in fatal accidents or serious injury, and damage
equipment or the environment.
CAUTION!
If the unit is found to be damaged externally or internally, or any of the accessories are damaged
or missing, contact SOCOMEC. Do not operate the unit if it has suffered a violent mechanical
shock of any kind.
NOTE!
Install the unit in accordance with clearances in order to prevent access to handling devices and
guarantee sufficient ventilation (refer to 'Environmental requirements' chapter).
NOTE!
Only use accessories recommended or sold by the manufacturer.
NOTE!
When the equipment is transferred from a cold to a warm place wait approx. two hours before
putting the unit into operation.
NOTE!
When carrying out electrical installation, all standards applicable specified by the IEC, in particu-
lar IEC 60364, and the electricity supplier must be observed. All national standards applicable to
batteries must be observed. For further information refer to 'Technical specifications' chapter.
WARNING!
Connect the protective earth (PE) conductor before making any other connections.
NOTE!
The installer is responsible for implementing the backfeed protection with the use of AC input
line isolation devices external to the UPS. Refer to 'Electrical requirements' chapter.
DANGER! RISK OF ELECTRIC SHOCK!
Before carrying out any operations on the unit (cleaning and maintenance performances,
connection of appliances, etc.) disconnect all power sources.
DANGER! RISK OF ELECTRIC SHOCK!
After disconnecting all power sources wait approx. 5 minutes for the complete discharge of the
unit.
NOTE!
The UPS may be powered from an IT distribution system with a neutral conductor.
NOTE!
Any use other than the specified purpose will be considered improper. The manufacturer/
supplier shall not be held responsible for damage resulting from this. Risk and responsibility lies
with the system manager.
YOUR CONNECTION TO SAFETY
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• www
.thiele-kg.de
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• www
.thiele-kg.de
YOUR CONNECTION TO SAFETY
klick to
www
u-s-v
YOUR CONNECTION TO SAFETY
klick to
www
ACDC-DCDC
YOUR CONNECTION TO SAFETY
klick to
www
SYSTEME
YOUR CONNECTION TO SAFETY
klick to
www
CONTACT
YOUR CONNECTION TO SAFETY
klick to
www
CALLBACK