SOCATA TB20GT, Руководство пилота

Страница: 152 / 213

SECTION 7
DESCRIPTION
SOCATA
MODEL TB 20
The content of this document is the property of
socata
. It is supplied in
confidence and commercial security of its contents must be maintained.
It must not be used for any purpose other than that for which it is supplied, nor
may information contained in it be disclosed to unauthorized persons. It must not
be reproduced nor transmitted in any form in whole or in part without permission
in writing from the owners of the Copyright.
Information in this document is subject to change without notice.
© 1988, 1991, 1992, 1994 to 1996, 1997, 2000 -
socata
- All rights reserved
Back to
Contents
June 30, 1988
Revision 8
7.25
SEATS, SEAT BELTS AND SHOULDER HARNESSES
FRONT SEATS
The various possibilities of seats adjustment depend on the version chosen.
– To move the seat forward and rearward (*) :
Use the adjustment bar located on the front part of the seat, under the
seating and grasp handle under instrument panel strip.
– To tilt the seat (*) :
Use the lever located on the outboard side of the seat.
– To change the seat back angle (if installed) :
Use the knurled knob located at the bottom part on the inboard side of the
seat back.
– To adjust the back, at lumbar level (if installed) :
Use the knob located over the knurled knob on the inboard side of the seat
back.
Press on the knob and moderately lean back to the desired position,
release the button, the seat back should fit perfectly with your back.
(*) Lift up adjustment bar or lever to unlock ; when in desired position,
release it and make sure it is locked.
REAR BENCH OR, Post–MOD.151, REAR SEATS
– To remove rear bench or rear seats, refer to Section 6 ” Weight and
Balance ”.
Rear bench or rear seats is/are not adjustable.
HEAD–RESTS (if installed)
– Before Model ”95” :
. To adjust and remove the head–rest :
Simply make it slide vertically.
. To fit the head–rest into the seat back :
Turn the centering bush (bearing an arrow) of
¼
turn clockwise (in the
arrow direction) and maintain it to fit the head–rest in the seat back.
. If oxygen equipment is installed, the masks are stored inside the
head–rests.
– Model ”95” :
. To install, adjust and remove the head–rest, simply make it slide
vertically.