SNR S2940-8G-v2, Руководство по настройке

Страница: 81 / 420

SNR S2940-8G-v2 Switch Configuration Guide
EFM OAM Configuration
10.3 EFM OAM Example
Example:
CE and PE devices with point-to-point link enable EFM OAM to monitor the First Mile link
performance. It will report the log information to network management system when occurring
fault event and use remote loopback function to detect the link in necessary instance
CE PE
802.1ah OAMPDU
1/0/1 1/0/1
Figure 10.3: Typical OAM application topology
Configuration procedure: (Omitting SNMP and Log configuration in the following)
Configuration on CE:
CE(config)#interface ethernet1/1
CE(config-if-ethernet1/1)#ethernet-oam mode passive
CE(config-if-ethernet1/1)#ethernet-oam
CE(config-if-ethernet1/1)#ethernet-oam remote-loopback supported
Other parameters use the default configuration.
Configuration on PE:
PE(config)#interface ethernet 1/1
PE(config-if-ethernet1/1)#ethernet-oam
Other parameters use the default configuration.
Execute the following command when using remote loopback.
PE(config-if-ethernet1/1)#ethernet-oam remote-loopback
Execute the following command to make one of OAM peers exiting OAM loopback after com-
plete detection.
PE(config-if-ethernet1/1)# no ethernet-oam remote-loopback
Execute the following command without supporting remote loopback.
CE(config-if-ethernet1/1)#no ethernet-oam remote-loopback supported
81