SNR S2940-8G-v2, Руководство по настройке

Страница: 33 / 420

SNR S2940-8G-v2 Switch Configuration Guide
Basic Switch Configuration
Command Explanation
Global Mode
snmp-server host { <host-ipv4-address> |
<host-ipv6-address> } { v1 | v2c | { v3 {
noauthnopriv | authnopriv | authpriv } } }
<user-string>
no snmp-server host { <host-ipv4-address>
| <host-ipv6-address> } {v1 | v2c | { v3 {
noauthnopriv | authnopriv | authpriv } } }
<user-string> Set the host IPv4/IPv6 address which is used
to receive SNMP Trap information. For SNMP
v1/v2, this command also configures Trap com-
munity string; for SNMP v3, this command also
configures Trap user name and security level.
The
no
form of this command cancels this IPv4
or IPv6 address.
snmp-server trap-source { <ipv4-address> |
<ipv6-address> }
no
snmp-server trap-source { <ipv4-
address> | <ipv6-address> }
Set the source IPv4 or IPv6 address which is
used to send trap packet, the no command
deletes the configuration.
9. Enable/Disable RMON
Command Explanation
Global Mode
rmon enable
no rmon enable Enable/disable RMON.
2.4.5 Typical SNMP Configuration Examples
The IP address of the NMS is 1.1.1.5 ; the IP address of the switch (Agent) is 1.1.1.9 .
Scenario 1: The NMS network administrative software uses SNMP protocol to obtain data
from the switch.
The configuration on the switch is listed below:
Switch(config)#snmp-server enable
Switch(config)#snmp-server community rw private
Switch(config)#snmp-server community ro public
Switch(config)#snmp-server securityip 1.1.1.5
The NMS can use private as the community string to access the switch with read-write permis-
sion, or use public as the community string to access the switch with read-only permission.
Scenario 2: NMS will receive Trap messages from the switch ( Note: NMS may have commu-
nity string verification for the Trap messages. In this scenario, the NMS uses a Trap verification
community string of usertrap).
The configuration on the switch is listed below:
Switch(config)#snmp-server enable
Switch(config)#snmp-server host 1.1.1.5 v1 usertrap
Switch(config)#snmp-server enable traps
Scenario 3: NMS uses SNMP v3 to obtain information from the switch.
The configuration on the switch is listed below:
33