SnowEx HELIXX, Руководство пользователя

Страница: 30 / 36

Lit. No. 31022EN, Rev. 00 30 June 1, 2022
REMOVING & STORING THE SPREADER
REMOVE SPREADER FROM VEHICLE
1. Disconnect the vehicle-side harness from the
hopper-side harness.
2. Remove both cotter pins and locking pins.
Remove the spinner drive assembly from the
hopper and set it aside.
3. Remove the frame spacer from in front of the
hopper and set it aside.
4. Remove the hopper mounting hardware from the
frame mounting holes and tie-down straps.
5. Lift the spreader and remove it from the vehicle.
To lift the spreader, remove the top screen.
Using slings or chains, lift the spreader by the four
diagonal corner rails.
CAUTION
Before lifting, verify that the hopper is empty
of material. The lifting device must be able to
support the spreader's weight as shown in
the Spreader Specifications table.
WARNING
Never remove the spreader with material in
the hopper.
Use all four rails
when lifting.
REMOVING & STORING THE SPREADER
STORE THE SPREADER
The spreader can be stored in vehicle position on
blocks or stands. Make sure the supports are stable
and the ground beneath is firm enough that the
spreader will not shift over time.
1. Remove the chute from the hopper body. Store
the chute in a horizontal position. It may be placed
inside or on top of the hopper if desired.
2. Remove the hopper mounting bolts and tie-downs.
3. Attach slings to the four corner lift points and,
using a hoist, lift the hopper out of the vehicle.
Move the spreader to the storage location with the
hoist or lower it onto blocks and use a forklift to
move it to a secure location.
4. The hopper body should be slightly tilted toward
the chute end to prevent any rainwater from
pooling in the hopper.
5. Use blocking to ensure that the spreader is stable.
CAUTION
Before lifting, verify that the hopper is empty
of material. The lifting device must be able to
support the spreader's weight as shown in
the Spreader Specifications table.