SnowEx HELIXX, Руководство пользователя

Страница: 24 / 36

Lit. No. 31022EN, Rev. 00 24 June 1, 2022
OPERATING THE SPREADER – CAB CONTROL
Table continues on next page.
Error Codes – Spreader Operation Stopped
Code Definition Possible Cause Suggested Solution
bb
Bad button. Button is stuck.
Button was pressed while
vehicle ignition was entering
ACC or START mode.
Inspect control. Free up button.
Do not press any spreader cab control buttons
while the vehicle ignition is being engaged.
bH Bad hopper. Possible module or control
mismatch.
Replace control or module. Use only genuine
service parts. Contact authorized dealer.
CE No communication with
spreader module.
Loose connection.
Module lost power.
Disconnected spreader
harness while vehicle is ON.
Confirm that spreader and control harnesses are
connected to the vehicle harness. Check power
to spreader module, all connections, fuses, and
power studs. Check that port B is plugged in.
CP
Spinner drive assembly
present fault.
Spinner drive assembly
harness is not attached.
Install the spinner drive assembly harness. Reset
the control by pressing the ON/OFF button.
Ct
Control is hot. Cab temperature is too high.
Control overheated.
Turn OFF spreader and allow control to cool off.
EF
Excessive drive faults. Too many
HO
and/or
SO
error codes; hopper module
overheating.
Control times out for 60 seconds.
Ensure that the auger and/or spinner are not
jammed.
Setup Codes
Code Definition Procedure
Cb Calibrate the Empty Hopper setting. With control in ON mode, press and hold the left control knob until the
Cb code displays. Calibration cycle is automatic.*
Cc Clear calibration data for Empty Hopper
setting; clear EH code.
Press the right control knob to clear all calibration data during the
calibration cycle.
LS Set LED brightness level. With control in Ready mode, press and hold the left control knob
to get LS code. Release pressure and turn the left control knob to
desired brightness setting. Wait for confirming
SL
code to display.*
SL Confirms that LED brightness level has
been reset.
* For full instructions, see "Setup Procedures" in the Operating the Spreader – Cab Control section of this manual.
Information Codes
Code Definition Response
Ar
Auto-reverse sequence is active. The spreader will automatically detect and attempt to clear a jam. See
the Operating the Spreader section of this manual.
dU
Spreader is in dump mode:
• Spinner drive assembly is removed.
• Material Feed buttons are enabled.
To operate the dump function, see instructions in the Operating the
Spreader section of this manual.
If dU code displays when the spinner drive assembly harness is
attached, contact authorized dealer.
EH Empty hopper (beep will sound). Check hopper for material.
Recalibrate Empty Hopper setting as described above for Cb code.
Lb Low battery. Hopper module is sensing
<10V. ( Lb becomes an error code
when module senses <6V.)
Refer to the Lb row under "Error Codes" (next table).
CAB CONTROL CODES