SnowEx HELIXX, Руководство пользователя

Страница: 27 / 36

Lit. No. 31022EN, Rev. 00 27 June 1, 2022
OPERATING THE SPREADER
OPERATING THE SPREADER
If auto-reverse is unsuccessful, then the operator must
extract the material that is causing the problem. Follow
all warning directions when clearing jams.
SPREADING TIPS
• Spread ice melters with the storm to prevent
unmanageable levels of ice.
• Never exceed 10 mph (16 km/h) when spreading.
• For a wider pass, increase spinner speed.
• For a heavier pass, drive slower or increase
auger speed.
• Never operate spreader near pedestrians.
• Calculate spread pattern when near vegetation.
NOTE: The spinner motor is not designed for
continuous duty. Allow the motor to cool between
long cycle times.
AUTO-REVERSE (Ar) FEATURE
The spreader is automatically able to sense and clear
material jams. The sensitivity level of the auto-reverse
feature is adjustable.
Adjusting the Auto-Reverse (Ar) Setting
1. With the spreader connected and the control
powered up in the READY mode, press and hold
the BLAST button. After 5 seconds, a number will
appear on the status display (factory default is 20).
2. Continue to hold the BLAST button and turn
the right-hand knob to control the material flow
setting (range is 2–30). Turn the knob clockwise to
increase the flow. Turn the knob counterclockwise
to decrease the flow.
3. Release the BLAST button.
4. Press the ON/OFF button twice (turning the
spreader ON, and then OFF) to save the setting.
5. If auto-reverse is too sensitive or not sensitive
enough, repeat Steps 1–4 and adjust the value. If
the value is set to 30, the auto-reverse feature will
be disabled
.
Auto-Reverse (Ar) Sequence
The Ar sequence will begin automatically and consist
of a series of reverse-then-forward movements of the
auger.
The Ar sequence will make up to five attempts to
clear the jam. The status display will flash Ar then a
number, and repeat as it counts down from 5 to 1. If
the jam is cleared, the auger will automatically return
to normal operation at the previous control settings.
CAUTION
Disconnect electric power and tag out, if
required, before servicing or performing
maintenance.