SnowEx HELIXX, Руководство пользователя

Страница: 20 / 36

Lit. No. 31022EN, Rev. 00 20 June 1, 2022
OPERATING THE SPREADER – CAB CONTROL
OPERATING THE SPREADER – CAB CONTROL
POWERING THE CONTROL
Power is not applied to the control until the vehicle
ignition is turned to ACC or ON. Once the control
has power it performs a light check and displays the
software version on the status display. The control
then checks for a connected spreader. If no spreader
is detected, the control does the following:
• nC (no connection) appears on the red status
d isplay for five seconds;
• A single beep;
• Control enters Standby mode with no lights
illuminated.
If any button is pressed on the control, it will wake and
check again for spreader connection. If no spreader is
detected, it will act as described above. If a spreader
is detected, it will transition to Ready mode.
Material
Width
Material
Flow
VIBRATE LIGHT STROBE PREWET
MIN MAX
ON/OFF
MIN MAX
BLAST
Material Width
Control Knob
(spinner speed)
Indicator Lights
(8 per knob)
Material Flow
Control Knob
(feed rate)
BLAST Button
(maximum application)
ON/OFF Button
& Emergency Stop
Status/Error Code
Display (red)
Accessory
Control Buttons
WARNING
Never operate equipment when under the
influence of alcohol, drugs, or medications that
might alter your judgment and/or reaction time.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
WARNING
Never allow children to operate or climb on
equipment.