Snorkel S3215E, Руководство оператора, Страница: 54 / 90

Chapter 9 – Operation
46
S3215L/S3215E/S3219E/S3220E/S3226E/S4726E/S4732E – 1500834
Note
The upper controls will not operate while the control
selector is in the lower position.
4. Enter and exit the platform using three points of
support. Grasp the handrails, not the doors, with one
hand on each side. Use two hands and one foot on
the step when climbing into and out of the platform.
5. From the upper controls, pull the emergency stop
button outward (refer to Figure 9.2).
Figure 9.2 – Upper Controls
6. The aerial platform may be driven and the platform
may be raised and lowered from the upper controls.
Push the emergency stop button inward when the
upper controls are not in use to protect against un-
intentional operation.
Removable Upper Controls/Side Drive
An optional removable upper control box or a side drive
pendant may be provided on the machine.
Danger
Pinch points may exist between moving components.
Death or serious injury will result from becoming
trapped between components, buildings, structures,
or other obstacles. Maintain at least 39
″
(1 m) clear-
ance around the machine before moving the chassis
or platform. Allow sufficient room and time to stop
movement to avoid contact with structures or other
hazards.
Maintain at least 39 ″
(1 m) between yourself and the ae-
rial platform when operating either the removable upper
controls or the side drive pendant from the ground outside
of the platform.
Platform
Use three points of support when entering or exiting the
platform. Grasp the handrails, not the doors, with one
hand on each side. Use two hands and one foot on the
step when climbing into and out of the platform.
Use care when entering and exiting the platform to avoid
slipping and/or falling. Securely close the entry doors
when the platform is occupied.
Danger
The potential for an accident increases when the fold
down rails are lowered. Death or serious injury will
result in such accidents. Do not elevate the platform
with the fold down rails lowered. Use extreme care
when moving the aerial platform while the fold down
rails are lowered.
If the machine is equipped with fold down guardrails, be
sure they are up and their hardware is securely tightened,
anytime the machine is not being transported.
Raising and Lowering
The raise speed is proportional to the joystick position.
The farther the joystick is moved, the faster the platform
raises. There is only one lowering speed.
1. Place the drive/lift selector switch (refer to Figure 9.2)
in the lift position.
2. Squeeze and hold the interlock switch against the
joystick.
y
To raise the platform, slowly pull the joystick
backward until the desired height is reached.
y
To lower the platform, push the joystick forward.
Lowering Interrupt – CE/AS/NZS
When the platform is lowered to about 6
′
(1.8 m) lower-
ing stops, the flashing light is constant on and the alarm
sounds in fast short beeps. The platform will not lower for
five seconds regardless of the joystick position.
Center the control in neutral to reset the lowering function,
then continue to lower the platform.
Upper Controls – Top
Upper Controls – Front
Emergency Stop Button
Horn
Drive/Lift
Selector Switch
Drive Range
Switch
Steer Switch
Interlock Switch
Battery Condition Indicator
Joystick