Snell MV-16, Руководство пользователя

Страница: 32 / 92

MV-16 Multiviewer www.snellgroup.com Operation
Issue 1 Rev 12 Page 32 © 2013 Snell Limited
3.5.2 Alarm Tab
The Alarm Tab allows each video and audio alarm to be configured, enabled and displayed.
The properties section of this window allows each alarm to be set individually for onset and
auto-clear delay, logging status and visibility in objects and lists.
To select an alarm to configure, click on it in the Select Alarm list on the left on the window.
The selected alarm will appear with its descriptive text highlighted in red. Choose the required
properties from the right hand section of the window and check the Enabled box to activate
the alarm.
An enabled alarm is shown with a green circle before the descriptive text.
Fig 25. Source Properties - Alarm Tab.
Select Alarm
Click on one of the alarms listed to change the attributes of it using
the controls listed under Properties.
Enabled Tick this to enable the selected alarm.
Delay Input a delay before the alarm starts.
Automatic Clearing
Check this for alarms to be automatically cleared after the Automatic
clearing delay.
Automatic Clearing
Delay
Input the automatic clearing delay in seconds.
Logging Maintain a log of triggered alarms.
Show in Objects Display alarms in objects.
Show in Alarm List Display alarms in the alarm list.
Send SNMP Check to send SNMP trap in response to alarm.
Use Audio Channel
Alarm Settings
Check to apply specified audio alarm detection criteria, as configured
in the Setup Audio Alarms menu.
Setup Audio Alarms Enters the audio alarm setup dialogue.
Table 19. Source Properties - Alarm Tab.
Note:
To setup audio alarms check the Use audio channel alarm settings box and click on Setup
Audio Alarms.