Not
for
Reproduction
13
en
WARNING
If the unit does not pass a safety test, do not
operate it. See an Authorized Service Dealer
authorized dealer.
Oil Recommendations
We recommend the use of Briggs & Stratton Warranty
Certified oils for best performance. Other high-quality de
-
tergent oils are acceptable if classified for service SF, SG,
SH, SJ or higher. Do not use special additives.
Outdoor temperatures determine the proper oil viscosity for
the engine. Use the chart to select the best viscosity for the
outdoor temperature range expected.
Checking/Adding Oil
Before adding or checking the oil
• Place engine level.
• Clean the oil fill area of any debris.
1. Remove the dipstick (
A
, Figure 2) and wipe with a
clean cloth.
2. Insert and tighten the dipstick.
3. Remove the dipstick and check the oil level. It should
be at the FULL mark (
B
) on the dipstick.
4. If low, add oil slowly into the engine oil fill (
C
).
Do not
overfill.
After adding oil, wait one minute and then
recheck the oil level.
NOTE
: Do not add oil at the quick oil drain (if equipped).
5. Replace and tighten the dipstick.
* Below 40°F (4°C) the use of SAE 30 will result in hard starting.
** Above 80°F (27°C) the use of 10W-30 may cause increased oil
consumption. Check oil level more frequently.
Operation
Safety Interlock System Tests
This unit is equipped with a Safety Interlock System.
Do not attempt to bypass or tamper with the switches/
devices.
TEST 1 — ENGINE SHOULD NOT CRANK IF:
• PTO switch is engaged, OR
• Ground speed levers are not locked in their START/
PARK positions.
TEST 2 — ENGINE SHOULD CRANK IF:
• PTO switch is NOT engaged, AND
• Ground speed levers are locked into their
START/PARK positions.
TEST 3 — ENGINE SHOULD SHUT OFF IF:
• Operator rises off seat with PTO engaged, OR
• Operator rises off seat with ground speed levers not
locked in their START/PARK positions.
TEST 4 — CHECK MOWER BLADE STOPPING TIME
The mower blades and mower drive belt should come
to a complete stop within five seconds after the electric
PTO switch is turned off. If mower drive belt does not
stop within five seconds, see your dealer.
NOTE:
Once the engine has stopped, the PTO switch
must be turned off and the ground speed levers must
be locked in their START/PARK positions in order to
start the engine.
Synthetic 5W
-30
Содержание 360Z Zero Turn Rider
Страница 2: ...N o t f o r R e p r o d u c t i o n 2...
Страница 32: ...N o t f o r R e p r o d u c t i o n...
Страница 62: ...N o t f o r R e p r o d u c t i o n...
Страница 92: ...N o t f o r R e p r o d u c t i o n...
