Snap-on Equipment EELR501A, Инструкция по установке и эксплуатации

Страница: 46 / 75

46 of 73
12.9
Runways
12.9.1 CHECK RUNWAYS
Check runways for damage or abnormal deformation. If such conditions exist, contact Snap-on
Equipment Technical Support.
12.9.2 INSPECT JACK BEAM TRACKS
Inspect rolling jack / oil drain pan tracks for cleanliness, corrosion, excessive wear or damage.
Clean dirty tracks. Worn or damaged tracks should be repaired immediately.
12.10
Front and Rear Steer Plates
12.10.1 VISUAL INSPECTION
Check front turn tables and rear slip plates for unusual deflection, damage, fluid spills. Clean or
further inspect if needed.
12.10.2 CLEAN REAR SLIP PLATES AND FRONT TURN TABLES
Clean foreign debris from front turn tables and rear slip plates by blowing out with compressed air.
Check and clean steer plates. Lubricate with oil or light grease.
12.10.3 MAINTENANCE OF REAR STEER PLATES
Inspect the non-skid coating on rear slip plates for wear. All areas found to be worn smooth should
be resurfaced with an Anti-Slip abrasive floor tread tape or a heavy duty Anti-Slip Floor Coating.
Remove rear slip plates. Clean runway surface and touch up any paint wear with a rust resistant
paint. Allow paint to dry thoroughly. Inspect transfer balls for excessive wear, deformations
or corrosion. Replace if needed.
12.10.4 ANTI-SKID COATING ON REAR STEER PLATES
Inspect the non-skid coating on rear steer plates for wear. All areas found to be worn smooth should
be resurfaced with an Anti-Slip abrasive floor tread tape or a heavy duty Anti-Slip Floor Coating.
12.11
Rolling Air Jacks
Lubricate roller bearings and roller guide springs.
Dismantle and clean lift arms.
Clean and lubricate rollers/sliders and hinge points.
Clean and lubricate safety mechanism.
Change hydraulic oil every two years.
12.12
Entire Lift
All lift components and moving areas should be kept free of corrosive agents, solvents, and
road salts. If such agents are spilled or splashed on any lift component, immediately rinse
thoroughly with water and wipe down with a clean rag. Lubricate again where the lubricate
required.
Check general operation of lift. Observe any structural noise, imbalance, binding, or other
malfunctions.
Failure to keep the lift free of corrosive agents and solvents will lead to
reduced component service life, cable failure, etc., which could result in
property damage and/or personal injury.