39 of 73
11.0 LIFT OPERATION
11.1
Raising the Lift
1. If the lift is equipped with sliding Jack Beam(s), be sure that the Beam(s) are positioned at the
front or mid travel of the lift, fully down, and with the risers removed and stored. Never store
Jack Beams at the rear of the lift.
2. Ensure that the lift is fully lowered before attempting to load or unload a vehicle.
3. Ensure that locking pins are secured in the front turntables and rear slip plates before driving a
vehicle onto the lift.
4. Position the vehicle on the lift ensuring the resulting load on the runway is distributed as
evenly as possible.
5. Chock the vehicle using the wheel chocks provided.
6. Check that there are no obstructions above the lift that could damage the lift or vehicles.
7. Raise the lift by pressing the up button on the control console. Raise the lift past the desired
working height until both mechanical safeties are heard engaging. Press the down button to
lower the lift down onto both of the mechanical safeties.
8. Verify that the lift is placed on the same safety lock for both sides.
NEVER WORK UNDER A VEHICLE OR THE LIFT UNLESS IT IS POSITIONED
ON BOTH MECHANICAL SAFETIES!
DO NOT RAISE OR LOWER THE LIFT WITH THE VEHICLE ON THE
JACKBEAM!
11.2
Lowering the Lift
1. Check that there are no obstructions under the lift or vehicle. Be sure that the sliding Jack
Beams are fully lowered and positioned at the front or mid section of the lift.
2. Raise the lift by pressing the up button until both runways are clear of their mechanical safety
locks.
3. Press the air safety release button to release the mechanical safeties.
4. While holding the air safety release button, press the down button and lower the lift to the fully
lowered position.
5. Remove wheel chocks and ensure that locking pins are secured in the front turnplates and
rear slip plates before driving a vehicle off the lift.
6. Be certain that the lift is completely lowered before removing the vehicle from the lift.
THE OPERATOR MUST ALWAYS KEEP THEIR ATTENTION ON THE
OPERATION OF THE LIFT WHILE RAISING OR LOWERING. IF AN
OBSTRUCTION IS SEEN, RELEASE BOTH THE AIR SAFETY RELEASE
BUTTON AND THE DOWN BUTTON TO STOP THE LIFT.
Содержание EELR501A
