Snap-on Equipment EELR501A, Инструкция по установке и эксплуатации

Страница: 20 / 75

20 of 73
Figure 14 – Air Control Valve and Air lines
3. Connect Air Hoses and Run Testing
- Uncoil the polytubes under each runway that is connected to the safety lock release air cylinder
shown on Figure 15 . Route these two lines from base frames to the union ‘Y’ connector in the
console. See
Figure 14
.
- Uncoil the polytube that one end is connected to the Terminal bolt for Jackbeam on the driver
side runway, shown on
Figure 15
. Connect other end to the Swivel Tee in the console, See
Figure 14
.
IMPORTANT: Use one 1/4" NPT cap to plug terminal bolt before connect to air supply.
- Mount a 1/4” NPT fitting ( not supplied) to the inlet port at FRL unit. Connect the shop air supply
line to this fitting. IMPORTANT: Shop air must be connected to the inlet port at the FRL unit
on the console, in order for lift to operate.
- Remove the black hex socket cap on the top of Lubricator, Fill the Lubricator Reservoir with
Snap-On Air Motor Oil #IM6 or Equivalent up to 4/5 of oil reservoir height, re-install the cap.
How to fill oil and adjustment reference to Section 12.3.
- After connecting the main air line, check the air system for any leaks.
Note: The console is equipped with an air Filter/Regulator/Lubricator to ensure a clean air
supply is provided to the safety release cylinders, Jackbeams, The Air Regulator should
be set between 0.62 - 0.83Mpa (90-120psi).