26 of 73
Note: These bolts must be removed
once the shims are installed under the
base correctly (same as the center
bolt on the base).
Figure 19 – Shimming
7.12
Anchoring Procedure
CAUTION!
WEAR PERSONAL PROTECTIVE EQUIPMENT (PPE) AND PRACTICE
CAUTION WHILE DRILLING CONCRETE.
Figure 20 – Anchoring
1. Using a rotary hammer drill and a 3/4” concrete bit, drill through the floor at each of the six (6)
anchor bolt locations beside the six (6) leveling bolts on each of the base frames.
Refer to
Figure 18
and
Figure 20
.
2. Assemble the nut and washer onto the 3/4” x 5-1/2” long wedge anchor bolts supplied.
3. Clean out the drilling dust from the holes and hammer in the anchors until they make contacts
with the baseplate.
4.
Torque all anchor bolts to
MAX. 110 lbs-ft (150 Nm).
5. Position the console in the final desired location see
Figure 4
. Using a rotary hammer drill
and a 1/4” concrete bit, drill and anchor the console to the floor using the Nail in Anchors
provided in the hardware kit.
If anchor bolts do not tighten to 110 lbs-ft (150 Nm). OR project more than 2-1/4” above the
concrete surface, the concrete should be replaced by an appropriate concrete pad.
Содержание EELR501A
