Installation Procedure (continued)
Refer to Figure 3 and Figure 4 for installation of the SMT-1100W. The SMT-1100W installation is similar to the installation of the
SMT-600W. Differences in the installation are easily recognizable and should present little difficulty in adapting the instructions for
the SMT-600W to the installation of the SMT-1100W.
Brackets, Hose Reel & Hose
Installation
Wall-mount brackets and
hose reel
- Brackets must be
installed on 16-inch centers
to align with the mounting
holes in the frame of the
pump and hose reel. Locate
the mounting-holes for the
brackets on the wall using
the template provided as
part of the shipping carton.
Install the two wall-mount
brackets with appropriate
hardware. If a wall-mount
hose reel is to be installed
with the pump unit it will
be attached with the same
hardware that attaches the
lower part of the wall-mount
brackets. Attach the brackets
to the wall with the top hole
in the bracket, and then
attach the hose reel to the
lower part of the brackets.
Install the hose reel and brackets together.
High-pressure hose
- Install the high-pressure hose on the hose reel by inserting the threaded end of the hose through the hole in
the flange of the reel and tighten into the fitting on the handle side of the reel. Wrap the threads of the fitting with several wraps of
Teflon tape. Secure the hose to the reel flange with the two rubber-coated clamps on the reel.
Main Pump Installation
Vibration/shock-mount
: Install four shock-mount pads onto the wall mount brackets following the directions in the instruction
sheet provided with the hardware kit. Loosely install the nuts on the shock-mounts on the underside of the brackets. These will be
wrench tightened after the pump is secured to the brackets.
Pump
: Remove the stainless steel cover from the pump.
• Place two 2-by-4’s across the two previously installed wall-mount brackets between and contacting the shock-mounts. Place
the pump on the 2-by-4’s, centered over the wall-mount brackets, with the blue tank to the left rear. Position the pump frame
to align the holes in the bottom of the frame with the shock-mounts. Screw the shock-mounts up into the frame 1/2 turn past
contact between the frame and the rubber.
• Remove the 2-by-4’s and lower the weight of the pump unit onto the shock-mounts.
• Tighten the nuts on the bottom of the shock-mounts until the shock-mounts just begin to bulge, and then tighten one full turn.
• Remove the straps holding hoses and power cords during shipment. Extend hoses and power cord behind and below the pump.
• Remove the black oil fill shipping cap from the top of the pump and replace with the red vent cap attached to the pump head.
Verify that the oil level in the pump is at the red dot on the oil level sight-glass.
Water supply hose
: Connect the 6-foot braided
water supply hose to the float valve. Connection is made at the underside of the pump frame-plate, beneath the blue float
tank, to the threaded ball-cock fitting.
DO NOT OVER-TIGHTEN.
Over-tightening will twist the float valve in the tank causing
the float to bind against the side of the tank. The supply end of the water supply hose will be connected to the water filter after
it is installed.
7
Assembly and Installation
Figure 3 - SMT-1100W Front View
Figure 4 - SMT-1100W Side View