Hardware and Tool Requirements
Mounting hardware
- Hardware for mounting to wood studs is included with your unit. This hardware may not be suitable for
many other type walls. Do not use hardware that is inadequate for your installation application.
Tools and supplies
- No special tools are required. Installation of this unit can be done with tools that are common to the average
service technician’s toolbox or are available at your local hardware store. Installation of the pump unit will be made easier and
safer with the use of two 24-inch 2-by-4’s. These 2-by-4’s will be laid across the wall-mount brackets to support the pump during
installation of vibration dampening mounts.
Utilities
Electrical
- Verify the dedicated circuit Voltage is correct for the Voltage of the unit being installed. Make sure the unit ON/OFF
switch is set to “OFF" prior to connecting the unit to the power receptacle.
Water pressure and flow rate - The water supply to the unit must have a flow rate of at least 5 GPM at a pressure of 30 PSI. Anything
less may cause intermittent shutdown of the system.
Water temperature
- Water supply temperatures in excess of 120° F will cause the unit to shut down to protect the pump seals from
damage. SMT recommends a water supply temperature of 120° F or less.
Installation Procedure
Refer to Figure 1 and Figure 2 for installation of the SMT600-W.
6
Assembly and Installation
WATER SUPPLY
BELOW UNIT
40
°
F-120
°
F RECOMMENDED
125
°
F MAXIMUM
4 GPM @ 30PSI
Figure 1 - SMT 600W Front View
Figure 2 - SMT 600W Side View
SIDE VIEW
ARCHITECTURAL DRAWING,
ASSEMBLED PRODUCTS CORPORATION
ROGERS, AR. 72756
TM
TM
SMT
12/10/07
TS
SMT 600W
Ceiling
16"
36"
32"
12" min
17"
14 1/4
12"
14" min
Ceiling
20 3/16
14" min
1 1/2"
1 1/2"
20 3/16"
17"
FRONT VIEW
TOP VIEW
ELECTRICAL SUPPLY
REQUIRED ABOVE UNIT
4' X 8', 3/4 PLYWOOD BACKING
48"
ACD-600W
System Requirements:
115V/20A Dedicated Circuit and/or 208V/230V, 15AMP, W 15-20 AMP Receptacle, Nema 5-20R or 6-15R (Rated for wet application)
4' x 8', 3/4" Backing Required in studded walls
Ambient Water Supply- Max Temp. 120 Deg. F., 5 Gpm @ 30 Psi with 3/4" Hose Bib (One For Each Unit)
NOTE: Electrical, Water, and Backing are not supplied by SMT
C
A
P
CHG
ECN#
DESCRIPTION OF CHG
DATE
BY
REL#
BY
DATE:
SCALE:
DATE:
USED ON:
DRWN BY:
CHKD BY:
PART NO.:
TITLE:
MATRL: