Smithco 76-000-D, Запчасти и обслуживание

Страница: 111 / 116

109
Par
ts
76-271 DUST/DIRT FILTRATION SYSTEM
REF# PART# DESCRIPTION QUANTITY
1* 76-249 Tailgate Screen for Filter
(28 x 58)
1
*15-437-01 Keeper 2
HRS-316-1125 Steel Rivet,
3
/
16
x 1
1
/
8
2
2* 76-247 Tailgate Filter
(28 x 57)
1
3* 76-246 Hopper Filter
(24 x 57)
1
4* 76-248 Hopper Screen for Filter
(24 x 28)
1
*15-437-01 Keeper 2
5 76-263 Hopper Screen Cover
(Serial Number 1000-1497)
1
76-359 Hopper Screen Cover
(Serial Number 1498 and Up)
1
6 76-261 Hopper Screen 1
7 76-262 Tailgate Screen 1
8 *15-437-02 Handle and Bracket 4
HRS-316-1125 Steel Rivet,
3
/
16
x 1
1
/
8
8
* 15-437 Latch (comes
with 15-437-01 and 15-437-02)
2
INSTALLATION INSTRUCTIONS
1. If your sweeper has a latch (Ref 8) on the tailgate screen, release the latch.
2. There is enough rubber trim to place on each short ends of the hopper and tailgate screens. This will
make a tighter seal. Do this before installing screens.
3. Remove tailgate screen (Ref 7) from tailgate. Unwedge the top and lift out of the bottom tab.
4. If your machine does not have the latch, please install it using the two steel
3
/
16
x 1
1
/
8
rivets we provide.
5. First, place the cloth filter (Ref 2) onto the tailgate screen, then place tailgate filter screen (Ref 1) over
the top of the cloth filter by placing the screen in to the bottom tab and wedging it into the top tab. The
keeper part of the latch is already riveted onto the tailgate filter screen.
6. Place the handle and bracket onto the keeper and bend over the side of the tailgate to the desired ten -
sion, mark where the two holes from the handle and bracket line up on the tailgate side panel.
7. You need to drill two
3
/
16
holes where your marks are, approximately centered on the curve and 1" from
edge of material, on each tailgate side.
8. Release handle end from keeper and place bracket end of latch handle over holes you drilled, attach
with two steel rivets.
9. Do this too both sides.
10. Remove the hopper screen cover (Ref 5) by unwedge the top and pulling it out of the bottom tab. You
cannot use this cover with the filtration kit.
11. Remove the hopper screen (Ref 6) from the hopper by unwedge the top and pulling it out the bottom
tab.
12. Place the cloth filter (Ref 3) onto the hopper, then place the hopper filter screen (Ref 4) over the top of
the cloth filter by placing the screen in to the bottom tab and wedging it into the top tab.