Smithco 100684, Запчасти и обслуживание

Страница: 79 / 94

77
Accessories
INSTALLATION
HOSES
Being careful not to cut the tubing, cut the over-sleeve back approximately 2" (5 cm) to expose blue and clear
tubing. Remove blue wing nut from top connector of foam nozzle and slide it on the blue tube with the threads
facing toward end of tube. Slide blue tube all the way over the top of the small tube on foam nozzle. Slide
wing nut back to the threads and hand tighten. Follow the same steps for the clear tube and tube nut.
Route the tubing along underside of main frame using tie downs as necessary.
Install opposite ends of air-liquid tubes to compressor, again cutting back the oversleeve approximately 2" (5
cm) and inserting blue and clear tubes for the left boom section into the tubing connectors on the right side
of compressor as far as possible. Follow the same steps for the right boom tubing. Notice the right boom is
inserted into left side of compressor. To release tubing from compressor, hold black ring around tubing, and
pull tube out.