Smithco 100684, Запчасти и обслуживание

Страница: 6 / 94

4
Ser
vice
MAINTENANCE
Before servicing or making adjustments to machine, stop engine and remove
key from ignition.
Use all procedures and parts prescribed by the manufacturer's. Read the en-
gine manual before operation.
LUBRICATION
Use No. 2 General purpose lithium base grease and
lubricate every 100 hours. The Spray Star 1000 has 7
lube points.
A. One on the rod end of hydraulic cylinder.
B. One on each the right and left spindles.
C. One on the reverse pedal.
D. One on each end of tie rod.
E. One on the forward pedal.
ELECTRICAL CONNECTIONS
Use dielectric grease on all electrical connections.
AIR CLEANER
1. Loosen cover retaining snaps and remove cover.
2. Remove pre-cleaner from paper element.
3. Check paper element. Replace element as necessary.
4. Wash pre-cleaner in warm water with detergent. Rinse pre-cleaner thoroughly until all traces of deter
-
gent are eliminated. Squeeze out excess water (do not wring). Allow pre-cleaner to air dry.
5. Saturate pre-cleaner with new engine oil. Squeeze out all excess oil.
6. Reinstall pre-cleaner over paper element.
7. Reinstall air cleaner cover. Secure cover with cover retaining knob.
WHEEL MOUNTING PROCEDURE
1. Set park brake. Turn machine off and remove key.
2. Block wheel on opposite corner.
3. Loosen nuts slightly on wheel to be removed.
4. Jack up machine being careful not to damage underside of machine.
5. Place wheel on hub lining up bolt holes.
6. Torque to 64-74 ft/lb (87-100Nm) using a cross pattern. Re-torque after first 8 hours and every 250
hours thereafter.
7. Lower machine to ground and remove blocks and jack.
TIRE PRESSURE
Caution must be used when inflating a low tire to recommended pressure. Over inflating can cause tires to
explode. All tires should be 20 psi (1.4bar). Improper inflation will reduce tire life considerably.