Smith HPW-60A, Руководство пользователя

Страница: 16 / 23

5. Setting the timers
Users can determine a time range for their showers so the heater can automatically ensure water is
heated during this period of time. At other times, the water heater will go into energy saving mode,
storing water at a lower temperature to optimize heat retention and thus, saving energy.
Before setting the timer, ensure the clock is adjusted to the right time. Note that the timer start time is
set first, followed by the end time. If users choose not to activate the timer function, press the
‘Program’ button repeatedly till the ‘Timer 1’ and ‘Timer 2’ indicator lights are off.
To program timer 1, press ‘Program’ button till only the ‘Timer 1’ indicator is lit, then press and hold
down the ‘Program’ button for 3 seconds till the time on the screen flashes. The indicator lights for
‘Timer 1’ and ‘Time On’ should be lit as you are now setting the start time for Timer 1. Press the “
‡ ”
the “
ˆ
” buttons to adjust the start time. The “
‡
” and “
ˆ
” buttons are programmed to make 30min
increments or decrements. Press the ‘Program’ button again to finalize the start time and to start
setting the end time. The end time is set in the same manner as the start time. While setting this
timing, the indicator lights for ‘Timer 1’ and ‘Time Off’ should be lit. For example, if the timer is set
from 20:30 – 22:00, the setting panels should look like these:
The directions for setting the second timer are the same as setting the first timer. The difference is that
while setting the second timer, ensure that the indicator light showing ‘Timer 2’ is lit before you press
and hold the ‘Program’ button to enter the setting mode.
Timer 1 adjustment period: 21:00 ~ 08:00
Timer 2 adjustment period: 12:00 ~ 21:00
To turn on both timers at the same time, press the ‘Program’ button until both indication lights for
‘Timer 1’ and ‘Timer 2’ are on. The ‘AES’ program and timer will not run simultaneously.
To view the timer settings, press the ‘Program’ button repeatedly to select either Timer 1 or Timer 2.
Press and hold down the ‘Program’ button for 3 seconds. The time that appears is the start time.
Press the ‘Program’ button again to show the end time. Press the ‘Program’ button again to exit the
menu.
16
Fig. 14
Fig. 15