Instructions for the installer
If the power cable is replaced, the
cross-section of wires in the new cable
must be no less than 1.5 mm
2
(3 x 1.5
cable), remembering that the end for
connection to the appliance must have
an earth wire (yellow/green) which is
at least 20 mm longer. Use only the
special cables available from Service
Centres.
The manufacturer cannot be held liable
for damage to persons or
things caused by failure to observe the above instructions or deriving
from tampering with any part of the appliance.
2.2
Room ventilation
The room containing the appliance should have a permanent air supply
in accordance with the standards in force. The room where the
appliance is installed must have enough air flow for the regular
combustion of gas and for the air exchange needed in the room itself.
The air vents, protected by grills, must be suitably dimensioned in
compliance with the current standards and positioned so that no part of
them is at all obstructed. The room must be kept adequately ventilated
in order to eliminate the heat and humidity produced by cooking: in
particular, after prolonged use, you are recommended to open a window
or to increase the speed of any fans.
2.3
Extraction of the combustion products
The combustion products must be extracted by means of hoods
connected to a natural draught chimney whose efficiency is certain or
via forced extraction. An efficient extraction system requires precision
planning by a specialist qualified in this area and must comply with the
positions and distances indicated by the applicable standards. When the
job is complete, the installer must issue a certificate of conformity in
accordance with applicable legislation.
41
