SMC Networks SMCSD10-Z, Руководство пользователя

Страница: 8 / 11

SMCSD10-Z Smoke Detector Guide
Copyright
©
2013 SMC Networks
Page 8
All Rights Reserved
I/M SMCSD10-Z rev. 1.0
6/18/13
E.
Squeeze the smoke chamber where indicated
by the alignment arrows, and pull it up and
away from the SMCSD10-Z and discard. See
the following figure.
F.
Blow out or use a soft-bristled brush to
remove dust and dirt from the smoke
chamber base.
G.
Line up the new smoke chamber with the
optical base by aligning the arrows on the
smoke chamber to the latches on the optical
base and snap down into place.
H.
Replace the detector cap by lining up the cap
with the smoke detector.
I.
Insert the cap into the smoke detector and
turn clockwise approximately 15 degrees.
The cap snaps firmly into place when secure.
J.
Insert the batteries into the smoke detector
using the proper polarity, and replace the
battery compartment cover.
K.
Reattach the SMCSD10-Z to its mounting
base.
L.
Test the smoke detector sensitivity and
contact the Central Monitoring Station to
place the system back online (exit Test
mode).
M.
Verify all auxiliary functions for a complete
test of the system.
Low Battery
Replace the batteries using the directions in
section 5 of this guide.
14
Troubleshooting
The SMCSD10-Z does not power up properly or
reports low battery.
 Be sure the batteries are fully seated within
the battery compartment and the polarity is
correct.

Check the battery voltage (3.0 VDC nominal).
Touchscreen does not respond.
 Follow the instructions in section 9 of this
guide to test the SMCSD10-Z link with the
Touchscreen.

Be sure the SMCSD10-Z is enrolled into the
Touchscreen properly.
 Check with your Cable Operator to make sure
you are using an approved Touchscreen with
compatible software.
Tamper condition does not restore.
 Be sure the SMCSD10-Z is installed properly
onto the mounting plate and the mounting
plate has a magnet.

Be sure there are no trouble indications at
the detector.
 Check with your Cable Operator to make sure
you are using an approved Touchscreen with
compatible software.
If a tamper alarm occurs.
 Remove the SMCSD10-Z from its mounting
base and reinstall.
 Check with your Cable Operator to make sure
you are using an approved Touchscreen with
compatible software.
Alarm/open condition does not restore.

Be sure the smoke or heat has cleared at the
SMCSD10-Z.

Check with your Cable Operator to make sure
you are using an approved Touchscreen with
compatible software.