- 79 -
No.JXC
※
-OMV0005-A
Problem
No.
Problem
Possible
causes
Investigation method and location
of possible causes
Countermeasures
1
PWR LED is
OFF.
Power fault
Check that PWR (green) of the
controller turns OFF at either of
when power is supplied, SVON
ON is instructed or the actuator
is operating.
Use an appropriate voltage and power supply
capacity in reference to the operation manual
of the actuator and controller connected.
→
3. Specifications (P.
→
5. External Connections (P.
C24V
Power fault
Check C24V voltage to the
JXCL1 controller PWR
connector.
Verify that the correct voltage is
supplied to the C24V terminal.
Connect the communication cable
correctly so that the connector is not
loose.
Incorrect
wiring
Check the incorrect wiring,
broken wire and short circuit of
the power supply plug for JXCL1.
Please correct the wiring in reference to
Controller Operation Manual.
→
5. External Connections (P.
→
6. Power Supply Plug (P.
2
ALM LED is
ON
Alarm
generated
If it is, check the type of alarm
referring to this manual.
Refer to the controller operation manual
and take appropriate measures.
→
16. Alarm for Motor Control (P.
ALM LED is
ON
and actuator
operates
abnormally
Misuse of
Data storage
Check the model number of the
controller to replace is the same
as the controller to be replaced.
Check the parameter for the
connected actuator was written
to the JXC controller with
JXC-BCW, if the controller is
replaced with JXCL1
-BC.
Replace with the JXC controller which is
the same model number of the controller
to be replaced. If the controller is
replaced with JXCL1
-BC, replace the
controller after writing the parameters
for the connected actuator with
JXC-BCW.
ALM LED is
flashing and
COM LED is
OFF
IO-Link
master
device
power
supply
failure
Check the power supply voltage
supplied from the IO-Link master
to the JXCL1 controller.
Verify that power is supplied to the
IO-Link master equipment.
Connect the communication cable
correctly so that the connector is not
loose.
Make sure that there are no
loose connectors, incorrect
wiring or broken wires in the
communication cables.
Connect the communication cable
correctly so that the connector is not
loose.
(Replace the cable if it is broken.)
3
COM LED is
ON
IO-Link
master
device
power
supply
failure
Check the power supply voltage
supplied from the IO-Link master
to the JXCL1 controller.
Verify that power is supplied to the
IO-Link master equipment.
Connect the communication cable
correctly so that the connector is not
loose.
Make sure that there are no
loose connectors, incorrect
wiring or broken wires in the
communication cables.
Connect the communication cable
correctly so that the connector is not
loose.
(Replace the cable if it is broken.)
JXC
controller
C24V
power
supply
failure
Check C24V voltage to the
JXCL1 controller PWR
connector.
Verify that the correct voltage is
supplied to the C24V terminal.
Connect the communication cable
correctly so that the connector is not
loose.
Make sure that there are no
loose wires, incorrect wiring or
broken wires in JXCL1 controller
PWR connector.
Connect the communication cable
correctly so that the connector is not
loose.
(Replace the cable if it is broken.)