27
Gener
al
3 positions
5 positions
Gener
al
26
Gener
al
3 positions
5 positions
Gener
al
Setting Procedures
Confirm the product is installed and connected properly and perform setting in the following
procedure.
!
Setting
Output signal
means ON, means OFF
means ON, means OFF
Input signal
Signal through I/O cable
Actuator condition
OUT1
External controll allowed
When motor side positioning completed
When end side positioning completed
When Intermediate stop 1 positioning completed
When Intermediate stop 2 positioning completed
Actuating
Alarm occurring
OUT2
OUT3
OUT4
Symbol
Command
IN1
Command to operate motor side
Command to operate end side
Command to operate intermediate stop 1
Command to operate intermediate stop 2
Command to operate intermediate stop 3
External input stop command
IN2
IN3
Symbol
Example of Internal Circuit and Wiring (continue)
Connection of the motor and the controller
(When controller separated type is used)
•Mind the direction of the connector and insert them until they click when connecting the cable.
•When pulling out the cable, pull them out while pressing connector lever.
Motor cable of
the actuator
Encoder cable of
the actuator
Encoder cable of
the controller
Connector
Motor cable of
the controller
Lever
Lever
Connector
Turn off the power during connecting.
The slider may run suddenly.
Do not pull the cable forcefully when
removing attaching / detaching the
connector.
Cable might be disconnected.
When Intermediate stop 3 positioning completed
External input stop operation is completed
OUT5
