SMC Networks C M2 Z Series, Руководство по эксплуатации

Страница: 11 / 28

- 10 -
3) Avoid storing the product in humid conditions.
Store the product with the piston rod retracted and avoid humidity, in order to prevent
generation of rust.
Caution
1) Preparation before piping
Before piping is connected, it should be thoroughly blown out with air (flushing) or
washed to remove chips, cutting oil and other debris from inside the pipe.
2) Wrapping of sealant tape
When screwing piping or fittings into ports, ensure that chips from the pipe threads or
sealing material do not enter the piping.
If a sealant tape is used, leave 1.5 to 2 threads exposed at the end of threads.
Fig. 2 Sealant tape
2-5. Speed control
When the piston speed is adjusted, install SMC AS series speed controller near the air
supply port to adjust to the specified speed. There are two methods of speed adjustment,
one is to restrict air supplied to the product, and the other is to restrict air exhausted from
the product. Normally, the latter method should be adopted.
Caution
Use a speed controller to adjust the cylinder drive speed, gradually
increasing from a low speed to the desired speed setting.
！
！
Wrap this way.
Sealant tape
Leave 2 threads exposed.