SMC Networks C M2 Z Series, Руководство по эксплуатации, Страница: 10 / 28

- 9 -
3) When an external guide is used, connect the piston rod end and the
load in such a way that there is no interference at any point within
the stroke.
4) Do not apply any torque to the cover jointed part.
The rod cover and head cover have wrench flats with sufficient width. Apply an
appropriate tightening force during mounting. Avoid working in a way such that one
cover is fixed and torque is applied to the other cover.
5) When female rod end is used, use a washer, etc. to prevent the
contact part at the rod end from being deformed depending on the
material of the work piece.
6) Do not hit or grasp the sliding parts of the cylinder tube and piston
rod with other objects.
Cylinder bores are manufactured to precise tolerances, so that even a slight deformation
may cause malfunction.
Moreover, scratches or dents, etc. in the piston rod may lead to damaged seals and
cause air leakage.
7) Prevent the seizure of rotating parts.
Prevent the seizure of rotating parts (pins, etc.) by applying grease.
8) Do not use the product until you have verified that the equipment
can operate properly.
Verify correct mounting by function and leak tests properly after compressed air and
power are connected following mounting or repair.
9) Do not let foreign matter such as cutting chips get into the product
from the suction port.
When the product is installed on a machine on site, the debris from drilled mounting
holes can get in the supply port of the product. Take sufficient care to prevent this.
Caution
When rod end female thread is used, use a thin spanner wrench when
tightening the piston rod.
2-4. Environment
Warning
1) Do not use in environments where there is a danger of corrosion.
2) Install a cover over the rod if it is used in an area that is dusty, or in
an environment in which water or oil splashes on the cylinder.
Contact SMC if the operating location contains a lot of dust.
！
！