Smart Openers Smart Slider, Руководство по установке

Страница: 5 / 20

-5-
Installation
Remember there are specific standards that have to
be strictly followed regarding the safety of electrical
installations and automatic gates and doors.
As well as the legal requirements and standards that
must be adhered to, please take note of the following
points to ensure maximum safety and reliability of your
installation.
1. Prior to installing check the surrounding environment.
Carefully evaluate any hazards there could be from
physical damage (transiting vehicles, parts of trees
falling etc.), possible contact with foreign bodies
(insects, leaves, etc.), Flooding hazards or any other
exceptional events.
2. Check that the mains voltage is the same as that
given on the rating plate and in this manual.
3. Check there is suitable electrical protection against
short circuits/power spikes and proper earthing on the
mains supply.
Remember the unit has mains voltage running through it
(electrocution hazard, fire hazard, etc).
4. Take care with the control unit; parts may be subject
to damage if abused.
5. Make sure you have all the necessary materials and
that they are suitable for this kind of use.
6. Read all the instructions thoroughly and make sure
they are understood before attempting to install the
Smart Slider.
7. Before starting the installation, carefully analyse all
the risks relating to automating the gate. Verify that
the gate to be automated is in a sound condition
and that the mechanisms are in good working order;
observe the safety margins and minimum distances.
8.
Evaluate with particular care the safety devices to be
installed and where to install them; always install an
emergency stop device for interruption of power to the
opener if required.
9. Once the risks have been analysed, install the Smart
Slider opener and relative safety devices, emergency
stop and/or photoelectric cells.
Important: For additional safety Smart Openers Pty Ltd
strongly recommends the fitting of Photo Electric safety
beams on all installations.
10. When installing the Smart Slider opener, strictly follow
all the instructions given in the instruction manual. If
some points or procedures in this manual are not very
clear do not install the unit until all doubts have been
cleared up with our technical department.
Pictured above is a typical LEFT HAND installation (from
inside the driveway looking out). Refer to the above
diagram for recommended installation.
1. Smart Slider gate opener
2. Power outlet
3. Gate Rack
4. Limit Stop Cam
5. Photo beam (RX/TX Type)
6. Digital Entry Keypad
7. 24V DC flashing light (optional extra)
1
2
3 4
5
6
7